Every time I share my planters with plant people I learn new things about drainage. I’m always happy to hear feedback on how to make my planters better homes for the plants that grow in them.
I will admit that sometimes I struggle initially with the feedback and how to incorporate it into my planters in the most effective way. There are lots of factors to consider from maintaining even, consistent wall thickness and other structural considerations to aesthetic considerations like continuing my personal style in the final form.
One such challenge revolved around adding additional drainage in the feet of my signature planter form. As you can sort of see from this angle, the method I use to form my planters’ feet creates low points in the pot where water can collect and cause root rot.
Here is a view of the planter upside down before any drainage holes are added.
The challenge was to decide the best way to avoid the low point.
Do I fill in the inside with additional clay? Well, that adds weight to the pot and the potential for uneven drying which can cause cracks.
Do I put in a thin layer of clay on the inside suspended over the low point? Then I create a hollow section in the pot and trapped air can cause explosions in the kiln during firing.
Do I fill in that part after the planter is completely fired with some non-clay material like caulk or silicone? I tried it on some pots I had already created and it works, but needs a lot more caulk, etc than it would appear. In addition to the added cost of the filler, the end result doesn’t look great.
In the end it was my second idea above that actually gave me the best solution. To release the trapped air in the pot I tried that idea on, I put holes in the bottom of the feet. The minute I did it, I realized, “Duh! Just put holes through the feet.”
It turned out to be the easiest, simplest solution and has the added benefit of being virtually invisible unless you look inside the pot or turn it over. So, now all of my planters from the very smallest to the largest have a minimum of five drainage holes (as pictured below).
At a recent show I learned that all of my drainage holes in my feet are actually helpful if the pot is used to plant bonsai since the initial planting requires the bonsai tree to be wired into the pot for security while it roots. So, there you have it! Two solutions in one – prevents root rot and allows for wire!
Looking for a great planter with absolutely fabulous drainage? Then be sure to check out my Etsy shop!